gd32f30x_usbd_hw.c
4.05 KB
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
/*!
\file gd32f30x_usbd_hw.c
\brief usbd hardware configure file
\version 2020-08-01, V3.0.0, firmware for GD32F30x
*/
/*
Copyright (c) 2020, GigaDevice Semiconductor Inc.
Redistribution and use in source and binary forms, with or without modification,
are permitted provided that the following conditions are met:
1. Redistributions of source code must retain the above copyright notice, this
list of conditions and the following disclaimer.
2. Redistributions in binary form must reproduce the above copyright notice,
this list of conditions and the following disclaimer in the documentation
and/or other materials provided with the distribution.
3. Neither the name of the copyright holder nor the names of its contributors
may be used to endorse or promote products derived from this software without
specific prior written permission.
THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS IS"
AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED.
IN NO EVENT SHALL THE COPYRIGHT HOLDER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT,
INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT
NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR
PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY,
WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY
OF SUCH DAMAGE.
*/
#include "usbd_hw.h"
/*!
\brief configure the different system clocks
\param[in] none
\param[out] none
\retval none
*/
void rcu_config(void)
{
uint32_t system_clock = rcu_clock_freq_get(CK_SYS);
/* enable USB pull-up pin clock */
rcu_periph_clock_enable(RCC_AHBPeriph_GPIO_PULLUP);
if (48000000U == system_clock) {
rcu_usb_clock_config(RCU_CKUSB_CKPLL_DIV1);
} else if (72000000U == system_clock) {
rcu_usb_clock_config(RCU_CKUSB_CKPLL_DIV1_5);
} else if (96000000U == system_clock) {
rcu_usb_clock_config(RCU_CKUSB_CKPLL_DIV2);
} else if (120000000U == system_clock) {
rcu_usb_clock_config(RCU_CKUSB_CKPLL_DIV2_5);
} else {
/* reserved */
}
/* GPIO clock */
rcu_periph_clock_enable(RCU_GPIOA);
rcu_periph_clock_enable(RCU_GPIOB);
rcu_periph_clock_enable(RCU_GPIOC);
rcu_periph_clock_enable(RCU_GPIOD);
rcu_periph_clock_enable(RCU_AF);
/* enable USB APB1 clock */
rcu_periph_clock_enable(RCU_USBD);
/* Timer clock */
rcu_periph_clock_enable(RCU_TIMER1);
rcu_periph_clock_enable(RCU_TIMER2);
rcu_periph_clock_enable(RCU_TIMER3);
/* SPI clock */
rcu_periph_clock_enable(RCU_SPI0);
rcu_periph_clock_enable(RCU_SPI2);
}
/*!
\brief configure the gpio peripheral
\param[in] none
\param[out] none
\retval none
*/
void gpio_config(void)
{
/* configure usb pull-up pin */
gpio_init(USB_PULLUP, GPIO_MODE_OUT_PP, GPIO_OSPEED_50MHZ, USB_PULLUP_PIN);
}
/*!
\brief configure interrupt priority
\param[in] none
\param[out] none
\retval none
*/
void nvic_config(void)
{
/* 2 bits for preemption priority, 2 bits for subpriority */
nvic_priority_group_set(NVIC_PRIGROUP_PRE3_SUB1);//(NVIC_PRIGROUP_PRE2_SUB2);
/* enable the USB low priority interrupt */
nvic_irq_enable((uint8_t)USBD_LP_CAN0_RX0_IRQn, 2U, 0U);//((uint8_t)USBD_LP_CAN0_RX0_IRQn, 2U, 0U);
/* enable the USB low priority interrupt */
nvic_irq_enable((uint8_t)USBD_HP_CAN0_TX_IRQn, 1U, 0U);//((uint8_t)USBD_HP_CAN0_TX_IRQn, 1U, 0U);
}
void systick_config(void)
{
/* setup systick timer for 1000Hz interrupts */
if (SysTick_Config(SystemCoreClock / 1000U))
{
/* capture error */
while (1)
{
}
}
/* configure the systick handler priority */
NVIC_SetPriority(SysTick_IRQn, 0x0fU);
}